10 Search Results

Pump-and-treat (P&T) is a common technique for groundwater remediation involving the extraction and treatment of contaminated water above ground. Optimizing the design and operation of the P&T well network is essential for maximizing the system’s effectiveness and efficiency. However, this optimization often necessitates many model evaluations, leading to computationally demanding tasks. This study introduces a novel approach that integrates analytical solutions for groundwater dynamics with the U-Net (Ronneberger et al., 2015) deep learning framework to predict groundwater contaminant plume migration under dynamic pumping conditions. By incorporating the Thiem equation (Thiem, 1906) into the input preprocessing, the U-Net model transforms sparsemore » well data into a continuous spatial field that captures the hydraulic impacts of pumping activities. This integration enables the model to leverage both deep learning capabilities and classical physics-based groundwater theories, enhancing prediction accuracy and computational efficiency. These advancements can facilitate rapid, large-scale evaluations of P&T optimization simulations, allowing for timely and effective decision-making in well placement and system management. We demonstrate the model's robust performance across both simplified transient 2D models and a more complex 3D heterogeneous site model at the 200 West P&T facility at the Hanford Site. The U-Net-based model offers substantial computational advantages, reducing simulation times significantly compared to full physics-based models and providing a powerful tool for rapid site evaluation and P&T system optimization, such as evaluating alternative P&T well network designs. Our findings highlight the potential of advanced machine learning models to significantly enhance the efficiency and sustainability of groundwater remediation efforts, offering a novel application of U-Net architecture in environmental science.« less

For geologic systems where carbon dioxide (CO₂) is injected underground, existing wells represent potential pathways for fluid migration. Here, this study introduces a novel deep learning model to quantify the likelihood and potential magnitude of fluid migration through wellbores at sites with intermediate aquifers or thief zones between the injection units and underground drinking water sources. Synthetic datasets, generated using reservoir simulations, captured a wide range of subsurface conditions, well attributes, operational parameters, and fluid migration scenarios. Among the regression models developed to predict brine and CO₂ leakage rates and CO₂ saturations along leaky wellbores, convolutional neural network (CNN) outperformedmore » both Light Gradient Boosting Machine and deep neural network. Additionally, a CNN-based classification model was created to predict whether brine and CO₂ would leak along a wellbore, further improving performance over regression alone. The best models were integrated into the National Risk Assessment Partnership Open-source Integrated Assessment Model for rapid, stochastic assessment of storage system containment and leakage risks. A case study demonstrated the model’s ability to simulate fluid migration through existing wells with multiple intermediate aquifers. This computationally efficient wellbore model offers value in support of site performance evaluation and risk-informed decision making by stakeholders.« less

Designs for Risk Evaluation and Management (DREAM) is a tool developed under the National Risk Assessment Partnership (NRAP) to enhance geologic carbon storage safety and efficiency. Using potential leakage scenarios generated externally by the users preferred history-matching approach, DREAM constructs ideal combinations of sensor locations in the right place at the right time to detect as many leaks as possible, detect them as early as possible, and minimize cost. This user-friendly tool, developed in Java, features a window-based GUI for input and a 3D visualization tool for viewing the domain space and optimized monitoring plans. DREAM's latest version accommodates real-worldmore » usage by allowing for joint optimization of wellbore point sensor placements and surface geophysics survey geometries, and by using more efficient multi-objective optimization algorithms. We show an example where, these two improvements combined allow us to support containment assurance and go from detecting 80–90 % of the potential CO₂ leakage to +99.7 %, a step-change improvement that can make the deciding difference in whether a site is suitable for geologic carbon storage. Though developed for geologic carbon storage, this tool would be equally applicable in many surface or offshore environmental monitoring projects.« less

Performing repeat pore-fluid sampling over long time-scales can provide valuable information on unsaturated zone contaminants and their potential flux to ground water. This information can be used to manage groundwater remedies and identify contaminants that need to be sequestered in the vadose zone to minimize flux to ground water. Pore-water samples are commonly used to obtain contaminant concentrations within the vadose zone, but existing methods are limited as they only provide a single sample at one location and time. The vadose zone advanced monitoring system (VZAMS) has been designed to integrate multiple technologies into a single down-borehole system that allowsmore » for sampling of pore fluids (liquid and gas) to provide information about contamination and hydraulic conditions at multiple depths (~0.3-m intervals) within a cased borehole. Testing has been completed at the laboratory scale to verify the sampling elements of VZAMS, including geochemical testing for representative contaminants known to exist at the Hanford Site, located in southeastern Washington State. Physical tests focused on the ability of the sampler to draw fluid under unsaturated conditions. Initial geochemical testing showed that the stainless steel material used with the porous cuff may affect the sampled concentrations of redox-sensitive contaminants under very dry conditions. Additional laboratory testing demonstrated that the VZAMS components are able to collect representative samples for substances of interest under expected field conditions. In this paper, the design and functionality of a novel instrument are demonstrated in support of subsequent testing in the field.« less

Abstract Historical use of lead arsenate as a pesticide in former orchards of eastern Washington State (USA) has resulted in legacy lead (Pb) and arsenic (As) soil contamination. However, the impacts on plant growth in soils with residual Pb and As contamination have not yet been quantified. To this end, a comparative study of plant growth impacts was performed for native bluegrass ( Poa secunda ), invasive cheatgrass ( Bromus tectorum ), and buttercrunch lettuce ( Lactuca sativa ). Using standard plant growth protocols, germination frequency and biomass growth were measured over a wide range of Pb and arsenate concentrations,more » with maximum concentrations of 3400 and 790 mg kg ⁻¹ for Pb and As, respectively. Results indicated that only the biomass growth for all species decreased in soils with the highest concentrations of Pb and As in the soil, with no impacts on soils with lower residual Pb and arsenate concentrations. No impact on percentage of germination was observed at any soil concentration. These results can be used to determine site‐specific soil screening levels for use in ecological risk assessments for Pb and arsenate in soils. Environ Toxicol Chem 2022;41:1459–1465. © 2022 Battelle Memorial Institute. Environmental Toxicology and Chemistry published by Wiley Periodicals LLC on behalf of SETAC.« less

For geologic carbon storage, the ability to detect secondary CO₂ plumes—defined as those CO₂ plumes accumulating outside the intended storage reservoir—is fundamental to preventing unexpected CO₂ migration into groundwater resources and for risk and liability management. Understanding the sensitivity of various geophysical methods to secondary plumes is crucial for designing cost-effective monitoring schemes. We use several modeling scenarios to demonstrate the process of assessing sensitivities and detection thresholds of three primary geophysical techniques—surface seismic, borehole-to-surface electromagnetic (EM), and surface and borehole gravity—for early detection of secondary CO₂ plumes in the post-injection phase. While seismic reflection methods are often considered inmore » monitoring strategies to track the evolution of CO₂ plumes, they are also the most expensive. Due to cost considerations, especially for long-term post-injection monitoring, other techniques complement seismic monitoring when designing an adaptive monitoring network. Borehole-to-surface EM or surface gravity surveys are feasible for time-lapse monitoring of deep secondary CO₂ plumes. Furthermore, these surveys could be carried at intervals defined by site-specific conditions. If time-lapse EM and/or gravity surveys detect any signal responses beyond the expected change, it would trigger a need for the higher resolution seismic survey.« less

In this study, the performance of both surface and borehole time-lapse gravity monitoring to detect CO₂ leakage from a carbon storage site is evaluated. Several hypothetical scenarios of CO₂ migration in a leaky fault, and thief zones at different depths at the Kimberlina site (California, USA) constitute the basis of the approach. The CO₂ displacement is simulated using the TOUGH2 simulator applied to a detailed geological model of the site. The gravity responses to these CO₂ plumes are simulated using forward modeling with sensors at ground surface and in vertical boreholes. Results of inversion on one scenario are also presented.more » The surface-based gravity responses obtained for the different leakage scenarios demonstrate that leakage can be detected at the surface in all the scenarios but the time to detection is highly variable (10–40 years) and dependent on the detection threshold considered. Borehole measurements of the vertical component of gravity provide excellent constraints in depth when they are located in proximity of the density anomaly associated with the presence of CO₂, thus discriminating multiple leaks in different thief zones. Joint inversion of surface and borehole data can bring valuable information of the occurrence of leakages and their importance by providing a reasonable estimate of mass of displaced fluids. This study demonstrates the importance of combining multiphase flow simulations with gravity modeling in order to define if and when gravity monitoring would be applicable at a given storage site.« less

Solid-phase interactions and speciation are important to radioiodine transport in groundwater. At the Hanford Site in Southeastern Washington State, iodate (IO₃^-) is the main aqueous species in dilute radioiodine groundwater plumes. Like other oxyanions, IO₃^- may be incorporated into and/or adsorbed onto calcite, a common mineral at Hanford, decreasing its mobility in the environment. A series of macroscale batch experiments combined with solid phase characterization were conducted to identify variables impacting time-dependent aqueous IO₃^- removal via calcite precipitation and determine the location of IO₃^- within the calcite crystal structure. Results demonstrated 11.5-97% aqueous IO₃^- removal during initial rapid calcite precipitation.more » Incorporation was apparently the main removal mechanism, although later slower precipitation and/or adsorption may have also contributed to IO₃^- removal. Using a higher concentration of the calcite forming solutions (i.e., using 1M vs. 0.1M concentrations) resulted in an increase in the amount of precipitated calcite and a greater percentage of IO₃^- removed; however, calcite formed with lower molarity solutions resulted in higher IO₃^- mass (µg/g) removal. Solubility testing of laboratory produced calcites showed only small differences in solubility for calcite with and without IO₃^- incorporated into the structure. Evidence collected from SEM/FIB and TEM/SAED suggested that the IO₃^- incorporated into calcite was present in regions close to surface (implying potential easy release upon calcite dissolution).« less

Here, we evaluated and compared the effectiveness of four surface-based geophysical monitoring methods to downhole pressure and chemical methods to detect brine and CO₂ leakage in underground sources of drinking water overlying a CO₂ storage reservoir. This assessment uses synthetic monitoring data generated from 400 simulated aquifer impact data sets. Here, the six monitoring techniques can detect impacted groundwater once 20,000 tonnes of CO₂ have leaked into the drinking water resource. Geophysical methods are most effective at detecting shallow plumes. Although downhole monitoring methods outperform geophysical methods in detecting deep plumes, geophysical methods may help reduce the false negative duringmore » the post injection site care because they detect impacted groundwater where downhole sensors may be absent.« less